Back to the list

HEADLIGHT BEAM ADJUSTMENT

  • 1
  • 2
  • 3
  • 4
  • 5

On vehicles fitted with this function, control A allows you to adjust the height of the beams according to the load.

Turn control A downwards to lower the headlights and upwards to raise them.

For manual settings

Examples of positions for adjusting control A according to the load

Halogen headlights

LED headlight

0

0

Driver alone or with front passenger

1

1

All seats occupied

1

2

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

2

3

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

4

4

To use according to the vehicle load

The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.

When driving on the left in a lefthand drive vehicle (or vice versa), you must adjust your lights temporarily during your stay.

Temporary adjustment

Open the bonnet and identify the marking B next to one of the front headlight projectors.

For each halogen headlight, use a screwdriver to turn the screw 1 by a quarter turn towards the - symbol to lower the beams.

Return to the original position once your trip is over: turn the screw 1 a quarter of a turn towards the + symbol to raise the beams.

For an LED headlight, use a screwdriver to turn the bolt 1 by a half turn towards the - symbol to lower the beams.

Return to the original position once your trip is over: turn the bolt 1 by a half turn towards the + symbol to raise the beams.