REAR LIGHTS AND SIDE LIGHTS: replacing the bulbs
Brake lights and direction indicator lights
Open the boot lid and remove screws 1.
Pull on the outside A of the light and remove the rear light unit.
Remove the bulb holder by releasing clips 2, then clips 3.
Change the bulb.
Refit the bulb holder and push the unit in fully until it locks in place.
Check that the light is properly locked in position.
Tighten screws 1.
4 Direction indicator lights
Bulb type: PY21W.
5 Brake light
Bulb type: P21W.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Side lights 6
Consult an approved dealer
High level brake light 7
Consult an approved dealer
Fog lights 9 and reversing lights 8
The front bumper needs to be removed; consult an authorised dealer.
Note: depending on the vehicle, the reversing and fog lights are inverted.
Bulb type: P21W.
Number plate lights 10
- Unclip light 10 by pressing tab 11;
- remove the light cover to gain access to the bulb.
Bulb type: W5W.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Side repeaters with bulbs 12
- Unclip the repeater 12 (using a flat-blade screwdriver type tool positioned at B to tilt the repeater towards the front of the vehicle);
- turn the bulb holder a quarter of a turn and take out the bulb.
Bulb type: WY5W.
LED side repeaters
(depending on vehicle)
Consult an approved dealer.