Back to the list

Headlight beam adjustment

  • 1
  • 2
  • 3
  • 4
  • 5

Headlight beam adjustment

Headlight beam adjustment

Switch A is used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.
The position selected is displayed on the instrument panel for approximately 30 seconds.
Note: depending on the vehicle, each time the ignition is switched on, the position selected is displayed on the instrument panel for approximately 30 seconds and for approximately five seconds each time switch A is pressed.
Examples of positions for adjusting the control A according to the load
0
Driver alone or with front passenger
1 or 2
All seats occupied
2 or 3
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
4
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.