Special features of petrol versions

  • 1
  • 2
  • 3
  • 4
  • 5

Special features of petrol versions

The following operating conditions:
  • driving for long periods when the low fuel level warning light is lit;
  • using leaded petrol;
  • using lubricant or fuel additives which are not approved.
Or operating faults such as:
  • a faulty ignition system, running out of fuel or disconnected spark plugs resulting in the engine misfiring or jerkiness while driving;
  • loss of power.
may cause the catalytic converter to overheat, reducing its efficiency which may irreparably damage it and cause heat damage to the vehicle.
If you notice any of the above operating faults, have the necessary repairs carried out as soon as possible by an approved dealer.
These faults may be avoided by regularly taking your vehicle to an approved Dealer at the intervals specified in the maintenance document.

Starting problems

To avoid damaging the catalytic converter or the starter, and to prevent premature wearing of the battery, do not keep trying to start the engine (using the start button, or by pushing or towing the vehicle) without having identified and corrected the starting fault.
If the fault cannot be identified, do not keep trying to start the engine, but contact an approved Dealer.
WARNING
Do not park the vehicle or run the engine in locations where combustible substances or materials such as grass or leaves can come into contact with the hot exhaust system.

Particle filter

The particle filter is used in the treatment of exhaust gases from petrol engines.
Depending on the vehicle, the warning light displayed on the instrument panel indicates that the filter is becoming clogged and requires cleaning. To clean it, when the warning light appears, and as traffic conditions and speed limits allow, drive at between about 31 mph (50 km/h) and 68 mph (110 km/h) until the light goes out.
After between approximately 5 and 20 minutes, the warning light should go out.
Note: the warning light may go out after 20 minutes if the driving conditions required to clean the filter are not fully met.
If the vehicle is stopped before the warning light disappears you will have to restart the process from the beginning.
If the filter becomes saturated, the warning light and, depending on the vehicle, the warning light appears on the instrument panel accompanied by the "Check injection" message. In this case, please consult an Authorised Dealer.
If the warning light and, depending on the vehicle, the warning light appear accompanied by the "WARNING: Engine Failure Risk" message, stop the vehicle and contact an approved dealer.
WARNING
For your own safety, the warning light requires you to stop immediately, as soon as traffic conditions allow. Switch off the engine and do not restart it. Call an approved dealer.