Back to the list
Assisted parking
Assisted parking
Using the ultrasonic detectors installed in the vehicle bumper, indicated by the arrows
3, this function helps to find accessible parking spaces and assists in the parking
manoeuvre.
Remove your hands from the steering wheel, you only control:
- the accelerator pedal;
- the brake pedal;
- the gear lever.
At any time, you can regain control by using the steering wheel.
Switching on
With the vehicle stationary or driving at less than approximately 19 mph (30 km/h):
- press the switch 2. The switch indicator light 2 lights up and display A appears on the multimedia screen 1;
- set the direction indicators to the side of the vehicle where you want to park.
Special features
Ensure that the ultrasonic sensors indicated by the arrows 3 are not obscured (by dirt, mud, snow, a badly fitted/attached number plate, etc.),
impacted, modified (including paintwork) or obstructed by any accessory fitted to
the front or rear of your vehicle.
Choice of manoeuvre
The system can perform four types of manoeuvre:
- parallel parking;
- perpendicular parking;
- angle parking;
- moving out of a parallel parking space.
From the multimedia screen 1, select the manoeuvre to carry out.
Note: when starting the vehicle, or after having successfully completed parallel parking
using the system, the default manoeuvre proposed by the system is assistance in exiting
a parallel parking space. In other cases, the default manoeuvre can be set from the
multimedia screen 1. Please refer to the multimedia instructions for further information.
Tip
The system start up is accompanied by the activation of Park Assist and, on those
vehicles equipped, the reversing camera or 360° camera to help the driver visualise
the manoeuvre PARKING DISTANCE CONTROL, REVERSING CAMERA and 360° CAMERA.
Operation
Parking
As long as the vehicle speed is less than 19 mph (30 km/h), the system searches for
available parking spaces on the side of the vehicle chosen by the driver.
Note: if parking spaces are available on the other side of the vehicle, set the direction
indicators to the other direction to enable the system to search for spaces on that
side.
Once a space has been found, it is displayed on the multimedia screen and indicated
by a small letter "P".
Drive slowly, with the direction indicators activated on the side where the space
is available, until the "Stop" message is displayed and a beep sounds.
The space is then indicated on the multimedia screen by a capital letter "P".
- Stop the vehicle;
- select reverse gear.
The indicator light lights up on the instrument panel and a beep sounds.
- Let go of the steering wheel;
- follow the instructions shown on the multimedia screen 1.
Your speed should not exceed around 4 mph (7 km/h).
Once the warning light on the instrument panel goes off and a beep sounds, the manoeuvre has been completed.
WARNING
This function is an additional driving aid.
Therefore, it can under no circumstances replace the driver's vigilance and responsibility
during manoeuvres (the driver must always be ready to brake).
Exiting a parallel parking space
- Briefly press the switch 2;
- select "Exit parallel parking space" mode;
- activate the direction indicator lights on the side on which you wish to exit the vehicle;
- press and hold switch 2 (approximately two seconds).
The indicator light lights up on the instrument panel and a beep sounds.
- Let go of the steering wheel;
- carry out forward and backward manoeuvres following the instructions shown on the multimedia screen 1 and using the alerts provided by the Park Assist system.
Your speed should not exceed around 4 mph (7 km/h).
Once the vehicle is in a position to exit the parking space, the warning light disappears from the instrument panel, a beep sounds and a message appears
on the multimedia screen 1 to confirm that the manoeuvre is complete.
WARNING
When manoeuvring, the steering wheel may turn quickly: do not put your hands inside
and make sure that nothing is caught inside.
Suspending/Resuming the manoeuvre
The manoeuvre is suspended in the following cases:
- you take control of the wheel;
- the vehicle is stationary for too long;
- an obstacle in the direction of movement prevents the manoeuvre from being completed;
- the engine stops;
- a door or the luggage compartment is opened.
The indicator light on switch 2 goes out and the warning light disappears from the instrument panel, accompanied by a beep, to inform
you that the manoeuvre has been suspended.
The reason for suspending the manoeuvre will be displayed on the multimedia screen
1.
Make sure:
- you have let go of the steering wheel;
and
- that all doors and the luggage compartment are closed;
and
- that no obstacles are in the way of the direction of movement;
and
- that the engine is started.
If the switch warning light 2 flashes, this indicates that the system is once again available to resume the manoeuvre.
To resume the manoeuvre, press and hold the switch 2.
The indicator light on switch 2 lights up and the warning light is displayed on the instrument panel.
Follow the instructions shown on the multimedia screen 1.
Cancelling the manoeuvre
The manoeuvre is cancelled in the following cases:
- the vehicle speed has exceeded 4 mph (7 km/h);
- by pressing switch 2;
- you have performed more than ten forwards/backwards movements in one manoeuvre;
- the parking distance control sensors are dirty or obscured;
- the vehicle wheels have skidded;
- the manoeuvre has been suspended for too long.
The switch indicator light 2 and the warning light on the instrument panel disappear and a beep sounds to confirm that
the manoeuvre has been cancelled.
The reason for cancelling the manoeuvre will be displayed on the multimedia screen
1.
Warning
WARNING
This function is an additional driving aid.
This function is not under any circumstances intended to replace the due care and
attention of the driver, who should at all times be in control of the vehicle.
Make sure that the manoeuvre complies with the applicable traffic regulations in your
location.
The driver should always be ready for sudden incidents while driving: always ensure
that there are no small, narrow moving obstacles (such as a child, animal, pushchair,
bicycle, stone, post, towing equipment, etc.) in the blind spot when manoeuvring.
System servicing/repairs
- In the event of an impact, the alignment of the sensors may be changed and their operation may consequently be affected. Deactivate the function and consult an authorised dealer.
- Any work in the area where the sensors are located (repairs, replacements, exterior trim modifications, etc.) must be carried out by a qualified professional.
Only an authorised dealer is qualified to service the system.
In the event of system disturbance
Certain conditions may disrupt or impair operation of the system, such as poor weather
conditions (snow, hail, ice, etc.).
In the event of the system behaving abnormally, deactivate it and consult an authorised
dealer.
Risk of erroneous false alarms.
Limitations of the system operation
- The system cannot detect objects located in the sensor blind spots.
- Always visually check that the parking space proposed by the system is still available and contains no obstacles.
- The system must not be used when towing a trailer or when there is a towing or load carrying system on the vehicle or on surrounding vehicles.