FRONT SEATS
To move the seat forwards or back
Lift and hold the bar 1 to unlock the seat. Release the bar 1 once the seat is in the correct position and ensure that the seat is fully locked into position.
To raise or lower the seat base
(depending on vehicle)
Move the lever 2 as many times as necessary upwards or downwards until the required position is reached.
To tilt the seatback
Turn the knob 3, or, depending on the vehicle, pull the lever 4 to tilt the seat back to the desired position and make sure that the locking is correct.
Front armrest 5
(depending on vehicle)
To use the armrest
Lower the armrest 5 to the horizontal position.
To store away the armrest
Lift the armrest 5 to the storage position along the seat back.
For vehicles with a single sliding side door, in the event of an emergency, the rear passengers may exit the vehicle using the front door. To do this: raise the lever 6, keep it held while tilting the seatback and slide the seat forwards.
To place the seat into the comfort position, slide it rearwards.
Adjust the seat and make sure that it is correctly locked.
Heated seats
(depending on vehicle)
With the ignition on:
- Pressing the switch 7 on the required seat for the first time activates the heating system on high. Both switch indicator lights are illuminated;
- pressing the switch for the second time changes the heating to low. Only one warning light on the switch is lit;
- pressing for the third time turns the heating off.
The system, which has a thermostat, decides whether or not the heating is needed.
After making adjustments, make sure that the seatbacks are correctly locked in place.
For safety reasons, carry out any adjustments when the vehicle is not being driven.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use.