REAR HEADRESTS
Five-seater version
Position for using headrest 1
Lift the headrest fully until it locks.
Check that the bonnet is correctly locked.
To raise the headrest 1
Raise the headrest as far as it will go, then press tab(s) 2 and remove the headrest.
To put the headrest back in place 1
Insert the rods into the holes, press the tab(s) 2 and lower the headrest.
Check that the bonnet is correctly locked.
Headrest 1 storage position A
Press tab 2 and lower the headrest fully.
When the headrest is set at the lowest position, Athis is for storage only: it should not be in this position when a seat is occupied.
The headrest is a safety component; check that it is fitted and in the correct position.
Four-seater version
This version differs in that it has rear seatbelts and headrests on the rear side seats only.