Back to the list


  • 1
  • 2
  • 3
  • 4
  • 5

To move forwards or backwards

Depending on the seat, lift bar 1 or handle 4 to release it. Release the handle at the desired position and make sure that it is locked.

Adjusting the height of the driver’s seat

Move lever 3 as many times as necessary:

- upwards to raise the seat,

- downwards to lower the seat.

To tilt the seatback

Depending on the seat, lower or lift lever 2 and tilt the seatback until it reaches the required position.

ð Heated seats

With the engine running, activate switch 5; a warning light comes on.

For safety reasons, carry out any adjustments when the vehicle is not being driven.

We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.

Make sure that the seatbacks are correctly locked in place.

Nothing should be placed on the floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use.

Flat position

Depending on the vehicle, the seatback on the passenger side may be folded down onto the seat base to create a flat position.

- Hold handle 4 and move the seat as far back as possible;

- lower the headrest fully;

- hold the top of the seatback to lower it;

- pull lever 2 and pull the seatback down and forwards (the seat base will be positioned on the floor);

- make sure that there is nothing which will prevent the seat from moving;

- tilt headrest 5 so as to position it under the dashboard.

The seat locks automatically; make sure it is correctly locked.

Repositioning the seat

Make sure that nothing prevents the seat from moving.

- Pull lever 2 and lift the seatback, ensuring it is correctly locked;

- reposition the seat base, placing your hand on the front of the seat base.

When the rear bench seat is folded down, move the front seats carefully.

Maximum weight on the seat in the flat position: 80 kg, with the weight evenly distributed.

For safety reasons, carry out any adjustments when the vehicle is not being driven.

Be sure to hold the seatback when placing it in the flat position. Risk of injury.

Put your hand on the front of the seat base when repositioning it. Risk of trapping.

Version with front bench seat for two

The seatbacks can be folded down (in one or two sections).

To fold down the seatbacks

Pull on handles 6 and 7 to release the seatbacks and lower seatbacks A and B.

To refit the seatbacks

Refit the seatbacks and click them back into place.

For safety reasons, carry out any adjustments when the vehicle is not being driven.

To avoid all risk of injury, ensure that nobody is in the proximity of the moving parts. When moving the seat, make sure that nothing interferes with the moving parts and their locking.

Front seats

Operating faults

(depending on vehicle)

If the sliding side door does not work, lower handle 8, hold it while the seatback tilts and slide the seat forwards.

To place the seat into the comfort position, slide it rearwards.

Adjust the seat and make sure that it is correctly locked.