Back to the list

Blind spot warning

  • 1
  • 2
  • 3
  • 4
  • 5

Blind spot warning

Using information from the sensors installed on each side of the rear bumper (area G), the function warns the driver:
  • when another vehicle is within the detection zone C;
and/or
  • when there is a risk of collision with a vehicle that is in zone F and moving faster than your vehicle.
The function warns you when the vehicle is travelling at a speed above approximately 9 mph (15 km/h).
WARNING
This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.
Special feature
Ensure that zone G around the radars on each side of the rear bumper are not obstructed (by dirt, mud, snow, etc.).
If a radar is obscured, the "Side radars no visibility" message will appear on the instrument panel. Clean the radar area.
Indicator light 1
A warning light 1 is located on each door mirror 3.
Note: clean the door mirrors 3 regularly so that the warning lights 1 remain visible.
Operation
The function warns you when the speed of your vehicle is over 9 mph (15 km/h) and:
  • when a vehicle is in the blind spot area C and travelling in the same direction as your vehicle;
  • when a vehicle approaches quickly from the rear in an adjacent lane within the detection zone F.
If you overtake another vehicle, the indicator light 1 will only come on if that vehicle remains for a long enough time period in your vehicle's blind spot C.
Tip
The function does not notify the driver if the other vehicles are not moving.
Display D
First warning: direction indicator not activated, the warning light 1 indicates that a vehicle is detected in the blind spot area and/or that a vehicle is rapidly approaching from the rear in an adjacent lane.
Display E
Direction indicator activated, the 1 warning light flashes when the function detects a vehicle in the blind spot warning area and/or a vehicle is rapidly approaching from the rear on the side towards which you will turn the wheel. If you cancel the direction indicator, the function will return to the initial warning (display D).
Conditions for non-function
  • When driving on a road with tight bends;
  • in reverse.
If the vehicle is equipped with a towbar recognised by the system, the "Trailer: side radars OFF" message displayed on the instrument panel informs you that the function is not operational. For information on the range of equipment adapted to your vehicle, we advise you to consult an approved Dealer.
Tip
The system’s detection range operates according to a standard lane width. If driving on a narrow lane, the function may warn you when a vehicle is detected further away than the nearest lane.

Operating faults

If the system detects a fault, the "Check Side radars" message is displayed on the instrument panel. Consult an approved Dealer.
Tip
Due to the presence of sensors behind the bumper, it is advisable to entrust any operation on the bumper (repair, replacement, paintwork, etc.) to a qualified professional.

Warnings

WARNING
The system’s detection range operates according to a standard lane width. If you are driving in wide traffic lanes, the system might not be able to detect a vehicle in the blind spot.
There is a risk of accidents.
WARNING
This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.
The driver should always adapt their speed to the traffic conditions, regardless of the system indications.
The system should under no circumstances be taken to be an obstacle detector or an anti-collision system.
System servicing/repairs
  • In the event of an impact, radar alignment may be changed, and its operation will consequently be affected. Consult an approved Dealer.
  • Any work in the area where the radars are located (repairs, replacements, etc.) must be carried out by a qualified professional.
Only an authorised dealer is qualified to service the system.
System disturbance
Some conditions can disturb or damage the system's operation, such as:
  • complex surroundings (metal bridges, tunnels, roads with barriers at the edge, etc.);
  • poor weather conditions (snow, hail, black ice, etc.).
Risk of false alarms or absence of warnings
If the system behaves abnormally, consult an approved dealer.
WARNING
Limitation of the system operation
  • The radar area should be kept clean and free of any modifications in order to ensure the proper operation of the system.
  • Small objects moving close to the vehicle (motorcycles, bicycles, pedestrians, etc.) may not be recognised by the system.
  • When turning into a bend, the radars may temporarily cease to detect vehicles in adjacent lanes.
  • The function may warn you late when two other vehicles are approaching from the rear, side by side in the adjacent lanes (driving on a 3-lane road) and at a much higher speed than your vehicle.
  • The system may not provide a warning when the other vehicles are travelling at a significantly different speed.
  • If the vehicle is being overtaken by a long vehicle (e.g. heavy goods vehicle overtaking at a similar speed to the vehicle) the system may interrupt the warning before the end of the manoeuvre.
  • The vehicle is travelling on a winding road.