Back to the list

HEADLIGHT BEAM ADJUSTMENT

  • 1
  • 2
  • 3
  • 4
  • 5

Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel.

Note: depending on the vehicle, when the engine is started, the position selected is displayed on the instrument panel for approximately 30 seconds and for 5 seconds each time switch A is pressed.

Examples of positions for adjusting control A according to the load

Van version

Estate versions

Standard chassis

Long chassis

Standard chassis

Long chassis

(5-seater)

Long chassis

(7-seater)

Driver alone or with front passenger

0

0

0

0

0

All seats occupied

-

-

1

0

1

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

-

-

2

1

2

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

4

4

3

2

3

The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.

When driving on the left in a lefthand drive vehicle (or vice versa), you must adjust your lights temporarily during your stay.

Temporary adjustment

Open the bonnet and identify the marking B next to one of the front headlight projectors.

Operating principle

Using a screwdriver or similar, turn the bolt 1 a half turn towards the - symbol to lower the beams.

Return to the original position once your trip is over: turn the bolt 1 by a half turn towards the + symbol to raise the beams.