REAR HEADRESTS
Standard chassis version
(5-seater)
To raise it
Slide it to the required height.
To lower it
Pull it towards you and slide it to the required height.
To remove it
Raise the headrest then press tabs 1 to release it.
To refit it
Press tab 1 and insert the rods into the holes, with the notches facing forwards.
Storage position 2
Pull it towards you and lower it completely.
When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.
The headrest is a safety component; check that it is fitted and in the correct position.
Long chassis version
(5-seater or 7-seater)
Position for use
Lift the headrest fully until it locks. Check that the bonnet is correctly locked.
To remove the headrest
Raise the headrest as far as it will go, then press button 3 or 4 and remove the headrest.
To refit it
Fit the rods into their housing and push down the headrest until it locks to set it to raised position.
Check that the bonnet is correctly locked.
The headrest is a safety component; check that it is fitted and in the correct position.
Long chassis version
(continued)
Storage position 5 or 6
Press button 7 or 8 and lower the headrest completely.
When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.
The headrest is a safety component; check that it is fitted and in the correct position.