HEADLIGHTS: changing bulbs
Front side lights
Remove cover B and pull bulb holder 2.
Bulb type: W5W.
Note: once the bulb has been replaced, ensure the cover is refitted correctly.
Direction indicators
Remove cover A and turn bulb holder 1 a quarter turn.
To refit the bulb holder, position it correctly, as determined by the foolproofing device.
Bulb type: PY21W.
Note: once the bulb has been replaced, ensure the cover is refitted correctly.
To comply with current legislation, or as a precaution, you can obtain an emergency kit from an approved dealer containing a set of spare bulbs and fuses.
Dipped beam headlights
Remove cover E and turn bulb holder 6 a quarter turn.
Bulb type: H7LL.
Do not touch the bulb glass. Hold it by its base.
Note: once the bulb has been replaced, ensure the cover is refitted correctly.
Cornering lights
(depending on the vehicle)
Remove cover D and turn bulb holder 5 a quarter turn.
Bulb type: H7.
Note: once the bulb has been replaced, ensure the cover is refitted correctly.
Main beam headlights
Remove cover C.
Unclip the springs 4 and remove the bulb holder 3.
Bulb type: H1.
Note: once the bulb has been replaced, ensure the cover is refitted correctly.
To comply with current legislation, or as a precaution, you can obtain an emergency kit from an approved dealer containing a set of spare bulbs and fuses.
Before performing any action in the engine compartment, the ignition must be switched off (please see the information on “Starting, stopping the engine” in Section 2).
The bulbs are under pressure and can break when replaced.
Risk of injury.
Please note when working close to the engine that it may be hot. In addition, the engine cooling fan may start at any moment. The warning light in the engine compartment reminds you of this.
Risk of injury.