Back to the list


  • 1
  • 2
  • 3
  • 4
  • 5

You can decide whether you want to activate this function.

To activate

With the ignition on, press switch 1 for approximately 5 seconds until you hear a beep.

The indicator light built into the switch comes on when the doors are locked.

To deactivate

With the ignition on, press and hold switch 1 for approximately 5 seconds, until you hear a beep. The indicator light in the switch goes out.

Operating principle

When the engine is started, the system automatically locks the doors when the vehicle reaches a speed of approximately 4 mph (7 km/h).

Operating faults

If you notice an operating fault (automatic locking impossible), first check that all doors are correctly locked. If they are correctly locked and the fault is still present, contact an approved Dealer.

Also make sure that locking has not been inadvertently deactivated.

If it has, switch the ignition off and on again and reactivate it.

Driver’s responsibility

If you decide to keep the doors locked when you are driving, remember that it may be more difficult for those assisting you to gain access to the passenger compartment in the event of an emergency.