FRONT SEATS
Adjusting seat A
To move forwards or backwards
Lift handle 1 to release. Release the handle once the seat is in the correct position and ensure that the seat is locked.
To adjust the height of the seat base
Lower or pull lever 2 as many times as is necessary to raise or lower the seat base.
Lumbar adjustment
(depending on the vehicle)
Turn control knob 3 to increase or decrease support.
To tilt the seatback
Move lever 4.
Heated seats
(depending on the vehicle)
With the ignition on, press switch 5. The integrated indicator comes on.
After making adjustments, make sure that the seatbacks are correctly locked in place.
For safety reasons, carry out any adjustments when the vehicle is not being driven.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use.
Adjusting seat B with suspension
To move forwards or backwards
Lift handle 11 to release. Release the handle once the seat is in the correct position and ensure that the seat is locked.
To tilt the seatback
Lower or pull control 7 towards you.
To adjust the height of the seat base
Move control 9 to adjust the rear of the seat base or control 10 to adjust the front of the seat base.
Lumbar adjustment
Activate bulb 12 to make it firmer.
Press switch 13 to make it less firm.
To adjust the seat suspension
Turn control knob 6 to the right to stiffen the suspension and to the left to reduce it.
Heated seats
(depending on the vehicle)
With the ignition on, press switch 8. The integrated indicator comes on.
The system, which has a thermostat, decides whether or not the heating is needed.
Adjusting the pivoting seat C
To move the seat forwards or back
Move handle 15 to unlock it. Release the handle once the seat is in the correct position and ensure that the seat is locked.
To move the seat forwards or back
Lift handle 18 to move the seat base forwards or back.
To tilt the seatback
Lower or pull handle 14 towards you.
Adjusting the angle of the seat base
Move handle 16 to adjust the angle of the seat base.
Adjusting the height of the armrests
Turn control knob 17 or 19.
Lumbar adjustment
Activate bulb 22 to make it firmer.
Press switch 21 to make it less firm.
To pivot the seats
- Detach the seat belt buckle from its unit;
- raise the armrests;
- move the seat as far back as possible;
- adjust the seat base to its lowest position;
- adjust the seatback to the vertical position;
- open the door;
- lift handle 20 and pivot the seat to unlock it from its “forward-facing” position, then release handle 20.
Returning to the driving position
- Pivot the seat to the “forward facing” position;
- make sure the seat is correctly locked in position;
- adjust the seat to your driving position.
The “rear facing” seat position should only be used when the vehicle is stationary and the engine not running.