Front seats

  • 1
  • 2
  • 3
  • 4
  • 5

Front seats

WARNING
For safety reasons, carry out any adjustments while the vehicle is stationary.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of the driver) as these objects may slide under the pedals during sudden braking manoeuvres, thus obstructing their use.
WARNING
After making adjustments, make sure that the seatbacks are correctly locked in place.

Adjusting seat A

To move a seat forwards or backwards

Raise the handle 1 to unlock it. Release the handle once the seat is in the correct position and ensure that the seat is locked.

To adjust the height of the seat base

Lower or pull the lever 2 as many times as is necessary to lower or raise the seat base.

Lumbar adjustment

(depending on the vehicle)
Turn the control knob 3 to increase or decrease the support.

To tilt the seatback

Handle the lever 4.

Heated seats

(depending on the vehicle)
With the ignition on, press the switch 5. The integrated warning light comes on.

Adjusting seat with suspension B

To move a seat forwards or backwards

Raise the handle 11 to unlock it. Release the handle once the seat is in the correct position and ensure that the seat is locked.

To tilt the seatback

Lower or pull the control 7.

To adjust the height of the seat base

Handle the control 9 to adjust the rear of the seat base or control 10 to adjust the front of the seat base.

To adjust the seat suspension

Turn the control knob 6 to the right to stiffen the suspension and to the left to reduce it.

Heated seats

(depending on the vehicle)
With the ignition on, press the switch 8. The integrated warning light comes on.
The system, which has a thermostat, regulates the heating and deactivates it if necessary.

Lumbar adjustment

Use the lever 12 to increase the support.
Press the switch 13 to reduce the support.

Adjusting the pivoting seat C

To move the seat forwards or back

Use the handle 15 to unlock. Release the handle once the seat is in the correct position and ensure that the seat is locked.

To move the seat forwards or back

Raise the control 18 to move the seat base forwards or backwards.

To tilt the seatback

Lower or pull the control 14.

Adjusting the angle of the seat base

Move the control 16 to adjust the angle of the seat base.

Adjusting the height of the armrests

Turn the control knobs 17 or 19.

Lumbar adjustment

Use the lever 22 to increase the support.
Press the switch 21 to reduce the support.

To pivot the seats

  • Detach the seat belt buckle from its catch;
  • raise the armrests;
  • move the seat as far back as possible;
  • adjust the seat base to its lowest position;
  • adjust the seatback to the upright position;
  • open the door;
  • raise the control 20 and pivot the seat to unlock it from its "forward-facing" position, then release the control 20.

Returning to the driving position

  • Pivot the seat to the "forward facing" position;
  • make sure the seat is correctly locked in position;
  • adjust the seat to your driving position.
WARNING
The "rear facing" seat position should only be used when the vehicle is stationary and the engine is not running.