Back to the list


  • 1
  • 2
  • 3
  • 4
  • 5


To move the seat forwards or back

Lift handle 1 to release. Release the handle at the desired position and make sure that it is locked.

To raise or lower the seat base

Move lever 2 as many times as necessary upwards or downwards.

To tilt the seatback

Lift handle 3 and tilt the seatback to the desired position. Release the handle at the desired position and make sure that it is locked.

To adjust the seat’s lumbar position

Depending on the vehicle:

- move the switch 4 forwards, backwards, up or down;


- lower the handle 5 to increase the support and lift it to decrease it.

For safety reasons, make these adjustments only when the vehicle is stationary.

We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.

Nothing should be placed on the floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use.

Table function

Depending on the vehicle, the passenger seatback may be folded down onto the seat base to create a table.

- Lower the headrest;

- move the seat back;

- lift the lever 3 and tilt the seatback forwards as far as possible;

- pull the handle 7 and fully lower the seatback.

When using the passenger seat in table position, you must not use the two rear seats immediately behind it.

Repositioning the seat

Make sure that nothing prevents the seat from moving.

- Pull the handle 7 and raise the seatback, ensuring that it locks firmly in place.

- Reposition the seat base.

For your safety, attach any transported objects when the seat is in the table position.

Be sure to hold the seatback when placing it in the flat position. Risk of injury.

When the front seat is in table position, the front passenger airbag airbag must be deactivated (see the information on "Child safety: activating/deactivating the front passenger airbag" in Section 1).

Risk of serious injury caused by items resting on the seatback table which may be dislodged when the airbagairbag is deployed.

The label (on the dashboard) and the markings (on the windscreen) remind you of these instructions.

For safety reasons, carry out any adjustments when the vehicle is not being driven.



From the multimedia screen, you can access the driver’s seat massage function. On equipped vehicles, the switch 6 provides direct access to the “Massage” menu on the multimedia screen.

To activate the function:

- select the menu “Vehicle”, “Seats” then “Massage”;

- select the type of massage (“Tonic”, “Relaxing” or “Lumbar”);

- adjust the intensity (+ or -);

- adjust the speed (+ or -);

- reset the selected settings. Press 7 then “Reset”;

- activate/deactivate the massage seat (ON or OFF).

Note: the mode selected in the “Multi-Sense" menu may affect the massage configuration (please refer to the information in "Multi-Sense" in Section 3).

Please refer to the multimedia equipment instructions for further information.

Heated seats

With the ignition on:

- pressing the switch 8 on the required seat for the first time activates the heating system at maximum power. Both integrated switch warning lights come on;

- a second press decreases the heating to minimum power. One integrated warning light comes on;

- pressing for the third time turns the heating off.