HEADLIGHTS: changing bulbs
Direction indicator lights
Turn bulb holder 1 a quarter of a turn and take out the bulb.
Bulb type: PY21W.
Once the bulb has been replaced, check that it is properly secured.
Before performing any action in the engine compartment, the ignition must be switched off (please see the information on “Starting, stopping the engine” in Section 2).
Halogen dipped beam headlight
To change the bulb:
- remove cover A;
- turn the bulb holder a quarter turn 2;
- remove the bulb.
Bulb type: H7.
Halogen main beam headlight
To change the bulb:
- remove cover B;
- turn the bulb holder a quarter turn 3;
- remove the bulb.
Bulb type: H7.
It is essential to use anti-U.V. 55W bulbs so as not to damage the plastic on the headlights.
Do not touch the bulb glass. Hold it by its base.
When the bulb has been changed, make sure you refit the cover correctly.
The bulbs are under pressure and can break when replaced.
Risk of injury.
LED dipped beam/main beam headlights 5
Please see an authorised dealer.
Daytime running lights and side lights 4
Please see an authorised dealer.
LED fog lights 6
Available depending on equipment.
Please see an authorised dealer.
Additional lights
If you wish to fit fog lights to your vehicle, please see an authorised dealer.
To comply with local legislation, or as a precaution, you can obtain an emergency kit containing a set of spare bulbs and fuses from an approved dealer.
Please note when working close to the engine that it may be hot. In addition, the engine cooling fan may start at any moment. The warning light in the engine compartment reminds you of this.
Risk of injury.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Any operation on (or modification to) the electrical system must be performed by an approved dealer since an incorrect connection might damage the electrical equipment (harness, components and in particular the alternator). In addition, your Dealer has all the parts required for fitting these units.
VEHICLE PRESENTATION
