Back to the list

REAR HEADRESTS

  • 1
  • 2
  • 3
  • 4
  • 5

Position for use

Lift the headrest fully until it locks. Check that the bonnet is correctly locked.

To remove the headrest

Lower the seatback slightly, press the tab 1 and remove the headrest.

To refit the headrest

Insert the headrest rods into the sleeves, and lower the headrest until it locks.

To adjust the angle of the headrest

Depending on the vehicle, move section A towards or away from you to the required position.

To adjust side supports

Depending on the vehicle, sections B can be adjusted independently to the desired position.

Storage position 2 for the headrest

Press tab 1 and lower the headrest completely.

When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.

The headrest is a safety component; check that it is fitted and in the correct position.