Back to the list

REAGENT TANK

  • 1
  • 2
  • 3
  • 4
  • 5

Please ensure that you comply with the legislation of your country.

It is important to remember that failure to respect regulations in force could lead to legal action being taken against the vehicle owner.

Operating principle

The reagent is intended for Diesel engines fitted with the SCR (selective catalytic reduction) system. Using the reagent reduces the quantity of nitrogen oxides in exhaust gases.

Consumption in real time depends on vehicle usage conditions, the equipment fitted and the user’s driving style.

Reagent quality

Use only reagents which conform to standard ISO 22241 and in accordance with the mark on the tank filler cap.

Filling

Useable capacity of the tank: between approximately 4.84 gal and 5.5 gal (22 litres and 25 litres) (depending on the vehicle).

Ignition off, open the front left door to open the cover A. Unscrew the cap 1.

Note: ammonium hydroxide vapour may escape from the cap opening when the tank temperature is high.

To fill up with reagent, the engine must be stopped (not just on standby in the case of vehicles with the Stop and Start function). You must switch off the ignition STARTING, STOPPING THE ENGINE: vehicle with key, FUNCTION STOP AND START.

If the “XXX MILES (XXX KM) failure Top up AdBlue” warning message appears, fill the reagent tank and refer to the filling instructions.

Risk of immobilisation of the vehicle.

Filler cap: this is specific.

If you have to replace it, make sure it is identical to the original cap. Contact an approved Dealer. Do not wash the filler area with a high pressure washer.

Precautions for use

The tank can be filled at the pump. In other cases, it is essential to read the information shown on the reagent container (e.g. the can or bottle).

When filling, handle the reagent carefully. They can damage clothes, shoes, bodywork components etc.

If the reagent overflows, or contaminates any paintwork, clean the affected area quickly with plenty of cold water and a soft cloth.

Note: if the reagent crystallises, use a soft sponge.

In extreme cold weather conditions

In frosty weather conditions, the reagent tank should be refilled when the indicator and the message “TOP UP AdBlue before 1200 km” appear on the instrument panel.

Special cases

The reagent fluid freezes below approximately -10°C.

In these conditions, do not attempt filling when the fluid is frozen. In the event of needing to top up or fill the tank with reagent ( on), park the vehicle in a hotter location if possible so that the reagent becomes liquid again. Otherwise, have a qualified professional top up or fill up with reagent fluid.

After filling the reagent tank, check that the cap and cover are closed, start the engine and WAIT 10 seconds with the vehicle stationary, engine running before setting off again.

If this operation is not carried out, the filling of the tank will not be taken into account automatically until after several dozens of minutes of driving.

The message “--- TOP UP AdBlue” and/or the warning lights will continue to appear until the filling has been registered by the system.

The reagent must not come into contact with eyes or skin. If it does, wash the affected area with plenty of cold water. If necessary, consult a doctor.

No work whatsoever is permitted on any part of the system. To prevent damage, only qualified personnel from our network may work on the system.

Maintenance/Range

The information displayed on the instrument panel may be accompanied by a beep.

Indicator lights

Messages

What to do?

-

“ Top Up AdBlue before 2400 km“

When the message is displayed when the ignition is switched on, you have less than 1,488 miles (2,400 km) range.

Refill, or have an Approved Dealer refill the reagent in the tank.

appears.

“ TOP UP AdBlue before 1200 km“

When the message is displayed when the ignition is switched on, you have between 744 miles (1,200 km) and 496 miles (800 km) range.

Refill, or have an Approved Dealer refill the reagent in the tank.

appears.

“XXX KM failure Top up AdBlue”

The message is displayed when the ignition is switched on and is repeated:

- Approximately every 62 miles (100 km), you have between about 496 miles (800 km) and 124 miles (200 km) range;

- Approximately every 31 miles (50 km), you have less than 124 miles (200 km) range.

In any event, fill or have an Approved Dealer fill the reagent tank as soon as possible.

flashes or comes on, depending on the vehicle.

“0 KM failure Top up AdBlue”

The engine will not start.

To restart, you must fill the reagent tank yourself.

System faults

When the indicator lights light up, this may be accompanied by a beep.

Indicator lights

Messages

What to do?

and © come on.

“Check Anti- Pollution System”

“AdBlue quality to check”

“AdBlue injection to check”

Indicates a fault in the system. Contact your approved Dealer as soon as possible.

and © come on.

“XXX KM failure antipollution”

This indicates a system fault and that less than 621 miles (1,000 km) range remains or, depending on the vehicle, less than 497 miles (800 km) range remains until it is no longer possible to restart the vehicle.

These warnings are repeated:

- every 62 miles (100 km) until between approximately 621 miles (1000 km) and 124 miles (200 km) range remains or, depending on the vehicle, between 497 miles (800 km) and 124 miles (200 km) remains until it is no longer possible to restart the vehicle;

- Every 31 miles (50 km) when there is less than 124 miles (200 km) left before the vehicle cannot be restarted.

Contact your approved dealer as soon as possible.

and © come on.

“0 KM failure antipollution”

Indicates that after the ignition is switched off the vehicle will not restart. Call an approved Dealer.