Back to the list

WHEEL TRIM, WHEEL

  • 1
  • 2
  • 3
  • 4
  • 5

Wheel trim 1

Remove the wheel trim using hubcap tool 2 (located in the tool kit) by fitting the hook into one of the openings around the edge of the wheel trim.

To refit it, align it with valve 3.

Push the retaining hooks in fully, starting on the side of valve A, followed by B and C, finishing at Dopposite the valve.

Wheel trim 4

Remove using hubcap tool 2 (located in the tool kit) by engaging the hook in the opening near the edge of the trim.

To refit, position the five trim attachments facing the five wheel attachments and press hard in the middle of the trim to clip it to the wheel.

Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing to reduce the risk of injury.