REVERSING CAMERA
Operation
When the vehicle is reversing, the camera 1 on the luggage compartment lid transmits a view of the area surrounding the rear of the vehicle to the multimedia display 2 accompanied by two guiding lines 3 and 4 (fixed and mobile).
This system uses several guidelines for its operation (mobile for trajectory and fixed for distance).
When the red zone is reached, use the bumper image to stop accurately.
Fixed clearance gauge 3
The fixed clearance gauge comprises coloured markers A, B and C indicating the distance behind the vehicle:
- A(red) approximately 30 centimetres from the vehicle;
- B (yellow) approximately 70 centimetres from the vehicle;
- C (green) approximately 150 centimetres from the vehicle.
This gauge remains fixed and indicates the vehicle trajectory if the wheels are in line with the vehicle.
4 moving guide line:
This is shown in blue on the multimedia screen 2.
It indicates the vehicle trajectory according to the position of the steering wheel.
Special feature
Make sure that the camera is not obscured (by dirt, mud, snow, condensation etc.).
Activating, deactivating the reversing camera
To activate or deactivate the function from the multimedia screen 2, refer to the multimedia instructions.
Activate or deactivate the reversing camera and confirm your choice.
You can also adjust the camera image settings (brightness, contrast, etc.).
Operating faults
When reverse gear is engaged, if the system detects an operating fault, a black screen is displayed temporarily on the multimedia screen 2.
This may be caused by a fault affecting the camera or screen (clearness, fixed image, delayed communication etc.).
If the temporary display of the black screen persists, please consult an approved dealer.
This function is an additional aid.
It cannot, therefore, under any circumstances replace the vigilance or the responsibility of the driver.
The driver should always be ready for sudden incidents while driving: always ensure that there are no small, narrow moving obstacles (such as a child, animal, pushchair, bicycle, stone, post, etc.) in the blind spot when manoeuvring.
The screen shows a reverse mirror image.
The frames are a representation projected on a flat surface. This information is to not be taken into account when superimposed on a vertical object or an object on the ground.
Objects which appear on the edge of the screen may be deformed.
In very bright light (snow, vehicle in sunshine, etc.), the camera vision may be adversely affected.
If the boot is open or poorly closed, the message “WARNING: Boot Open” appears and the camera display disappears.
Difference between the estimated distance and actual distance
Reversing towards a steep uphill slope
The fixed guidelines 3 show the distances as closer than they actually are.
The objects shown on the screen are actually further away on the slope.
For example, if the screen displays an object at D, the actual distance of the object is at E.
Reversing towards a steep downhill slope
The fixed guidelines 3 show the distances as further than they actually are.
Therefore, the objects shown on the screen are actually closer on the slope.
For example, if the screen displays an object at G, the actual distance of the object is at F.
Reversing towards a protruding object
Position H seems further than position J on the screen.
However, position H is at the same distance as position K.
The trajectory indicated by the fixed and mobile guidelines do not take into account the height of the object.
So there is a risk that the vehicle may collide with the object when reversing towards position K.
