Back to the list

ELECTRIC WINDOWS

  • 1
  • 2
  • 3
  • 4
  • 5

Driver’s responsibility

Never leave your vehicle with the key inside, and with a child, a dependent adult or a pet, even for a short while.

They may pose a risk to themselves or to others by starting the engine or activating equipment (such as the gear lever or electric windows).

If any part of the body becomes trapped, reverse the direction of the window immediately by pressing the relevant switch.

Risk of serious injury.

Electric windows

Press the window switch down or lift it up to lower or raise the window to the desired height.

From the driver’s seat, use switch:

1 for the driver’s side;

2 for the front passenger side.

From the front passenger seat, move switch 3.

Avoid resting any objects against a half-open window: there is a risk that the electric window winder could be damaged.

When closing the windows, ensure that no part of the body (arm, hand, etc.) is protruding from the vehicle.

Risk of serious injury.

One-touch electric windows

When the vehicle is equipped with this function, the one-touch mode works in addition to the operation of the electric windows described previously.

It is only fitted to the driver’s window.

- Fully and briefly press down on the relevant switch down: the window will open completely.

- Fully and briefly lift the relevant switch: the window will close completely.

Pressing the switch again while the window is moving will stop its movement.

Note: if the window meets resistance when closing (e.g. tree branch), it stops and then lowers again by a few centimetres.

If you use the switch while the window is moving, it stops working.

Operating faults

In case of a fault when closing a window, the system reverts to normal mode: pull the switch concerned up as often as necessary to fully close the window (the window will close gradually), hold the switch (still on the closing side) for one second then lower and raise the window fully to reinitialise the system.

If necessary, contact an approved Dealer.

Half-opening window

To half-open the window, turn handle 4 (movement A) then lock it by pushing the handle to the right.

Make sure it is properly latched into position when it is closed.

Avoid resting any objects against a half-open window: there is a risk that the electric window could be damaged.