Back to the list
Exterior lighting: replacing bulbs
Exterior lighting: replacing bulbs
Front headlights
LED main beam headlights/dipped beam headlights/direction indicator lights 1
Consult an approved dealer.
LED daytime running lights/side lights 2
(depending on the vehicle)
Consult an approved dealer.
WARNING
Any operation on (or modification to) the electrical system must be performed by an
approved Dealer since an incorrect connection might damage the electrical equipment
(harness, components and in particular the alternator). In addition, your Dealer has
all the parts required for fitting these units.
Rear and indicator lights
LED side light/brake light 1
Consult an approved dealer.
Direction indicator lights 5
- Open the luggage compartment door;
- remove the trim 2;
- unscrew the nut 3;
- release the lights unit from outside the vehicle by pulling towards the rear;
- remove the bulb holder 4 by unscrewing it a quarter of a turn, then replace the bulb.
Bulb type:WY16W.
WARNING
The bulbs are under pressure and may break when replaced.
Risk of injury.
Refitting
To refit, proceed in the reverse order, taking care not to damage the wiring.
Tip
To comply with current legislation, or as a precaution, you can obtain an emergency
kit from your approved dealer containing a set of spare bulbs and fuses.
Fog lights and reversing lights 6
Consult an approved dealer.
High level brake light 7
Consult an approved dealer.
Number plate lights 8
- Unclip the light by pressing the tab 9;
- remove the light cover to gain access to the bulb.
Bulb type: W5W.
WARNING
The bulbs are under pressure and may break when replaced.
Risk of injury.
LED number plate lights 10
(depending on the vehicle)
Consult an approved dealer.
LED side repeaters 11
(depending on the vehicle)
Consult an approved dealer.
WARNING
The bulbs are under pressure and may break when replaced.
Risk of injury.
Special feature of version E-tech full hybrid
LED side light/brake light 12
Consult an approved dealer.
Direction indicator lights 13
- Open the luggage compartment door;
- remove the trim 14;
- unscrew the nut 15;
- release the lights unit from outside the vehicle by pulling towards the rear;
- remove the bulb holder 16 by unscrewing it a quarter of a turn, then replace the bulb.
Bulb type:WY16W.
WARNING
The bulbs are under pressure and may break when replaced.
Risk of injury.
Refitting
To refit, proceed in the reverse order, taking care not to damage the wiring.
Tip
To comply with current legislation, or as a precaution, you can obtain an emergency
kit from your approved dealer containing a set of spare bulbs and fuses.
Tip
When refitting the right-hand light, ensure that the duct 4 has been refitted in its original position.