Back to the list

REAR HEAD RESTS

  • 1
  • 2
  • 3
  • 4
  • 5



Position for use

Raise the headrest as far as possible to use it in the high position. Check that it is correctly locked.

Storage position

Press button A and lower the headrest completely.

When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.

To raise the headrest

Raise the headrest as far as it will go, then press button A and remove the headrest.

If necessary, fold the seatback down to take out the headrest (see the information on “Sliding rear bench seat” in Section 3).

To refit the headrest

Enter the rods in their housing and push down the headrest until it locks to use it in the high position. Check that it is correctly locked.

The headrest is a safety component; check that it is fitted and in the correct position. The top of the headrest should be as close as possible to the top of the head.