Back to the list

FRONT HEADLIGHTS: changing bulbs

  • 1
  • 2
  • 3
  • 4
  • 5

Accessing the bulbs

On the left-hand side of the vehicle, you will need to remove the air duct A to access the bulbs. To do this:

- remove the clips 3;

- unscrew the bolt 2;

- press the upper part of the fastening clips 1 to release the air duct A;

- slide the air duct A towards the front of the vehicle to release it.

After replacing the bulbs, you must put the air duct A back into position. To do this, perform the above operation in reverse.

Before performing any action in the engine compartment, the ignition must be switched off (please see the information on “Starting, stopping the engine” in Section 2).

On the right-hand side of the vehicle, you will need to remove the filler neck 4 for the windscreen washer tank to access the bulbs. To do this:

- unscrew the funnel 4;

- pull the funnel 4.

Please note when working close to the engine that it may be hot. The engine cooling fan may also start at any moment. The warning light in the engine compartment reminds you of this.

Risk of injury.

Direction indicator lights

Turn the bulb holder 5 a quarter of a turn and take out the bulb.

Bulb type: PY21W.

Once the bulb has been replaced, check that it is properly secured.

Halogen dipped beam headlight

To change the bulb:

- remove cover B;

- turn the bulb holder a quarter turn 6;

- remove the bulb.

Bulb type: H7.

Halogen main beam headlight

To change the bulb:

- remove cover C;

- turn the bulb holder a quarter turn 7;

- remove the bulb.

Bulb type: H7.

It is essential to use anti-U.V. 55W bulbs so as not to damage the plastic on the headlights.

Do not touch the bulb glass. Hold it by its base.

When the bulb has been changed, make sure you refit the cover correctly.

The bulbs are under pressure and can break when replaced.

Risk of injury.

LED dipped beam/main beam headlights 9

Please see an authorised dealer.

Daytime running lights and side lights 8

Please see an authorised dealer.

Halogen front fog lights 10

The front bumper needs to be removed; consult an approved Dealer.

Type of bulb: H11.

LED front fog lights 10

Consult an approved dealer.

To comply with local legislation, or as a precaution, you can obtain an emergency kit containing a set of spare bulbs and fuses from an approved dealer.

The bulbs are under pressure and can break when replaced.

Risk of injury.

Additional lights

If you wish to fit fog lights to your vehicle, please see an authorised dealer.

Any operation on (or modification to) the electrical system must be performed by an approved dealer since an incorrect connection might damage the electrical equipment (harness, components and in particular the alternator). In addition, your Dealer has all the parts required for fitting these units.

CORNERING LIGHTS

Although this video is not specifically for your vehicle, the principle described is identical

FRONT LIGHTS

Although this video is not specifically for your vehicle, the principle described is identical