Back to the list

Driver vigilance warning

  • 1
  • 2
  • 3
  • 4
  • 5

Driver vigilance warning

The driver vigilance warning is a function that analyses the behaviour of the driver (driving style, vehicle steering, etc.) and alerts them if there is a risk of falling asleep.
It takes into account indicators such as:
  • steering wheel movements;
  • driver actions on other systems (indicators, brake pedal, etc.).
WARNING
This function is an additional driving aid in case of risk of fatigue. The function does not operate on the vehicle. The function cannot, under any circumstances, replace the driver's responsibility during driving.
The driver must always adapt their driving according to their alertness, regardless of the system's indications.

Operation

The function is set to notify the driver if:
  • a few minutes have elapsed since the vehicle last stopped;
  • the vehicle speed is greater than approximately 43 mph (70 km/h).
If there is a risk of fatigue or impaired attention, the "Fatigue warning Have a break" message 1 is displayed on the instrument panel, accompanied by a beep.
Press switch 6OK to clear the alert. It is advisable to stop as soon as possible for a break.
After deleting the message, the system continues vigilance monitoring and issues a new warning if necessary.
Tip
The driver vigilance warning constantly monitors the driver's attention and can provide several warnings per journey.
The system resets every time the engine is started.

Warning activation/deactivation

WARNING
For safety reasons, carry out any adjustments while the vehicle is stationary.
Tip
Depending on the vehicle, depending on the length of time following the last time the engine was stopped, the alerts are reactivated:
  • when the vehicle is unlocked;
or
  • when a door is opened;
or
  • when the engine is restarted.
Tip
When the alerts are deactivated, the system continues to assess the driver's state of fatigue.
Tip
Depending on the vehicle, it may not be possible to deactivate alerts.

Activating, deactivating alerts using the 7 "My Safety" button

The alerts can be deactivated or activated using "Perso" mode in the "My Safety" function MY SAFETY.
If the alerts have previously been deactivated using "Perso" mode:
  • to deactivate the alerts, press the button 7 twice;
  • to reactivate alerts, press the button 7 once.

Activating and deactivating the alerts from the multimedia screen 8

To activate or deactivate the alerts, please refer to the multimedia instructions.
Select ON or OFF.

Activating, deactivating the alerts from the trip computer 2

(depending on the vehicle)
  • With the vehicle stationary, press the switch 3 as many times as required to reach the  tab or, depending on the vehicle, the  tab;
or
  • press switch 3 and repeatedly press control 4 or 5 to reach the  tab;
  • depending on the vehicle, press the switch 6OK;
  • repeatedly press control 4 or 5 to reach the menu, then press switch 6OK;
  • repeatedly press control 4 or 5 to reach the "DRIVING ASSIST" menu, then press switch 6OK;
  • repeatedly press control 4 or 5 to reach the "Vigilance warning" menu, then press switch 6OK;
  • press the switch 6OK again to activate or deactivate the warnings:
    • warnings enabled;
    • warnings deactivated.

Limitations of system operation

Some conditions can disrupt or damage the operation of the system, for example:
  • certain driving styles (incorrect driving etc.) ;
  • driving on a road in poor condition;
  • strong side wind;
  • The clock is wrongly configured (depending on vehicle);
  • winding roads;
  • trailer traction.

Operating faults

If the system detects a fault, the "Vigilance monit. to check" message and the warning light are displayed on the instrument panel.
Have the system checked by an authorised dealer.