HEADLIGHT BEAM ADJUSTMENT
Switch A is used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel.
Note: depending on the vehicle, when the engine is started, the position selected is displayed on the instrument panel for approximately 30 seconds and for 5 seconds each time switch A is pressed.
Examples of positions for adjusting control A according to the load | |||||
|---|---|---|---|---|---|
Van version | Estate versions | ||||
Standard chassis | Long chassis | Standard chassis | Long chassis (5-seater) | Long chassis (7-seater) | |
Driver alone or with front passenger | 0 | 0 | 0 | 0 | 0 |
All seats occupied | - | - | 1 | 0 | 1 |
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight | - | - | 2 | 1 | 2 |
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight | 4 | 4 | 3 | 2 | 3 |
The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled. | |||||
When driving on the left in a lefthand drive vehicle (or vice versa), you must adjust your lights temporarily during your stay.
Temporary adjustment
Open the bonnet and identify the marking B next to one of the front headlight projectors.
Operating principle
Using a screwdriver or similar, turn the bolt 1 a half turn towards the - symbol to lower the beams.
Return to the original position once your trip is over: turn the bolt 1 by a half turn towards the + symbol to raise the beams.